Got the first attenuator built. Tried it out but it didn't work. After doing a little problem diagnosis I realized that the diode was installed backwards. So I'll desolder it and try it again.
0 Comments
I ordered the parts for the attenuator that will be used for DF from Jameco. They arrived yesterday and I will bread board the circuit today and test it. I found the design at Joe Moell's web site http://www.homingin.com/joek0ov/offatten.html . Hope fully I can get three up and running for the UI launch next week.
I've ordered the parts for the attenuator that is required to reduce the incoming signal from the DF transmitter. Once built, this will allow me to reduce the signal strength when in close proximity so as to further get a direction with the antenna.
|
pblountCourse Instructor Categories
All
Archives
June 2016
|